No prior experience with 3D printers or 3D modeling is required for this workshop experience. We're going to be teaching you the basics of 3D printing from the ground up. We'll start with a general overview of 3D printing and then go into 3D modeling for beginners and how to start using the 3D printers at the workshop.

We have a couple delta 3D printers setup on a network that will process your 3D files automagically, so they are super easy and fun to use for any skill level.

Timeline for the evening:
6:00- 6:30 - Community time and Tour of The Garage
6:30 - 7:00 - Introduction to 3D Printing - Jesse Jenkins
7:00 - 9:00 - Tutorials on 3D printing and open time for Design and Print

If you need a laptop, please let us know in advance.

We offer this course with a sliding scale admission. Trades are welcome. Our suggested donation is $20.